GPS Installation Guide
Product Overview
1. Interface Definition
The GPS Device has a 7-pin inerface connector. It contains the connectino for power, and I/O. For Asset Tracking only, we will only examine 3rd PIN (RED WIRE) and 7th PIN (BLACK WIRE) The sequence and description of the connector are shown in the following figure:
INDEX | DESCRIPTION | COLOR | COMMENT |
---|---|---|---|
1 | RXD | Orange | N/A |
2 | TXD | Grey | N/A |
3 | VIN | Red | External Power Input, 8-32V |
4 | IGN | White | Ignition input |
5 | OUT1 | Yellow | N/A |
6 | OUT2 | Green | N/A |
7 | GND | Black | Ground |
1. Interface Definition
The GPS Device has a 7-pin inerface connector. It contains the connectino for power, and I/O. For Asset Tracking only, we will only examine 3rd PIN (RED WIRE) and 7th PIN (BLACK WIRE) The sequence and description of the connector are shown in the following figure:
INDEX | DESCRIPTION | COLOR | COMMENT |
---|---|---|---|
1 | RXD | Orange | N/A |
2 | TXD | Grey | N/A |
3 | VIN | Red | External Power Input, 8-32V |
4 | IGN | White | Ignition input |
5 | OUT1 | Yellow | N/A |
6 | OUT2 | Green | N/A |
7 | GND | Black | Ground |
2. Power Connection
VIN (pin 3)/GND (pin 7) are the power input pins from the cart battery. The input voltage range for this device is from 8V to 32V. The device is typically installed onto one battery of any cart/vehicle (12V/24V) without the need for external transformers.

2. Power Connection
VIN (pin 3)/GND (pin 7) are the power input pins from the cart battery. The input voltage range for this device is from 8V to 32V. The device is typically installed onto one battery of any cart/vehicle (12V/24V) without the need for external transformers.

3. LED Description
GPS Device has two status LEDS: CELL LED (Green color) and GPS LED (Red color).

3. LED Description
GPS Device has two status LEDS: CELL LED (Green color) and GPS LED (Red color).

4. Getting Started
Parts List
GPS Tracker

Extension Harness

Connect the extension harness in the image below to the GPS Tracker. The male end to the female end.

After connecting the extension harness, the image should look like you can now connect the red wire and black wire end to the cart battery.
Connect the extension harness in the image below to the GPS Tracker. The male end to the female end.

After connecting the extension harness, the image should look like you can now connect the red wire and black wire end to the cart battery.
4. Getting Started
Parts List
GPS Tracker

Extension Harness

Connect the extension harness in the image below to the GPS Tracker. The male end to the female end.

After connecting the extension harness, the image should look like you can now connect the red wire and black wire end to the cart battery.
Connect the extension harness in the image below to the GPS Tracker. The male end to the female end.

After connecting the extension harness, the image should look like you can now connect the red wire and black wire end to the cart battery.